Version 5.8 387 October 2009
SIP User's Manual 6. Configuration Parameters Reference
Parameter Description
IP2IPRouting_AltRouteOptions;
[\IP2IPRouting]
For example:
IP2IPRouting 1 = -1, *, *, *, *, 0, -1, -1, , 0, -1, 0;
Notes:
This table can include up to 120 indices (where 0 is the first
index).
For a specific routing rule to be effective, the matching
characteristics must match. If no matching rule is located,
the call is rejected.
The destination can be one of the following:
9 Registered user Contact in the device's database (only
for USER IP Groups).
9 Destination IP Group's Proxy Set.
9 Specific destination (IP address, host name, port,
transport type, and/or SRD). Routing to a host name
can be resolved using NAPTR/SRV/A-Record.
9 Incoming Request URI.
If neither Destination SRD nor Destination IP Group are
configured, the destination SRD is the source SRD and the
destination IP Group is its default IP Group.
For a detailed description of the table's individual
parameters and for configuring the table using the Web
interface, refer to ''Configuring the SBC IP2IP Routing
Table'' on page 186.
For a description on configuring ini file table parameters,
refer to ''Format of ini File Table Parameters'' on page 273.
Web: SBC Alternative Routing Reasons Table
[SBCAlternativeRoutingReasons]
This ini file table parameter configures the SBC Alternative
Routing Reasons table. This table is used for alternative IP-to-
IP routing (defined in the 'IP2IP Routing' table). If 4xx, 5xx, or
6xx SIP responses are received as a result of outgoing SIP
dialog-initiating methods (e.g., INVITE, OPTIONS, and
SUBSCRIBE messages), the device re-sends the messages
(to an alternative route) if the response is defined in this table
and if there are alternative routes configured in the 'IP2IP
Routing' table.
The format of this parameter is as follows:
[ SBCAlternativeRoutingReasons ]
FORMAT SBCAlternativeRoutingReasons_Index =
SBCAlternativeRoutingReasons_ReleaseCause;
[ \SBCAlternativeRoutingReasons ]
For example:
SBCAlternaiveRoutingReasons 0 = 403;
SBCAlternativeRoutingReasons 1 = 404;
Notes:
This table can include up to five indices (where 0 is the first
index).
For a description on configuring ini file table parameters,
To Next Page
Loading...
