AudioCodes mediapack MP-500

Version 5.8 421 October 2009
SIP User's Manual 6. Configuration Parameters Reference
Parameter Description
NumberMapTel2Ip_NumberType,
NumberMapTel2Ip_NumberPlan,
NumberMapTel2Ip_RemoveFromLeft,
NumberMapTel2Ip_RemoveFromRight,
NumberMapTel2Ip_LeaveFromRight,
NumberMapTel2Ip_Prefix2Add,
NumberMapTel2Ip_Suffix2Add,
NumberMapTel2Ip_IsPresentationRestricted,
NumberMapTel2Ip_SrcTrunkGroupID,
NumberMapTel2Ip_ SrcIPGroupID;
[\NumberMapTel2Ip]
For example:
NumberMapTel2Ip 0 =
01,$$,*,0,0,2,$$,$$,971,$$,$$,$$,$$;
NumberMapTel2Ip 1 =
10,10,*,255,255,3,0,5,100,$$,255,$$,$$;
Notes:
 This table parameter can include up to 100 indices.
 The parameters SourceAddress and
IsPresentationRestricted are not applicable. Set these
to $$.
 The parameters NumberMapTel2Ip_ SrcIPGroupID,
NumberMapTel2Ip_NumberType and
NumberMapTel2Ip_NumberPlan are not applicable. Set
these to $$.
 The parameter RemoveFromLeft, RemoveFromRight,
Prefix2Add, Suffix2Add, LeaveFromRight, NumberType,
and NumberPlan are applied if the called and calling
numbers match the DestinationPrefix and SourcePrefix
conditions.
 The manipulation rules are executed in the following
order: RemoveFromLeft, RemoveFromRight,
LeaveFromRight, Prefix2Add, and Suffix2Add.
 Parameters can be skipped by using two dollar signs
('$$').
 To configure manipulation of destination numbers for
Tel-to-IP calls using the Web interface, refer to
''Configuring the Number Manipulation Tables'' on page
195).
 For a description on using ini file table parameters, refer
to ''Format of ini File Table Parameters'' on page 273.