AudioCodes mediapack MP-500

SIP User's Manual 422 Document #: LTRT-12801
MP-500 MSBG
Parameter Description
Web: Destination Phone Number
Manipulation Table for IP to Tel Calls
EMS: EMS: SIP Manipulations >
Destination IP to Telcom
[NumberMapIP2Tel]
This ini file table parameter manipulates the destination
number of IP-to-Tel calls. The format of this parameter is
as follows:
[NumberMapIp2Tel]
FORMAT NumberMapIp2Tel_Index =
NumberMapIp2Tel_DestinationPrefix,
NumberMapIp2Tel_SourcePrefix,
NumberMapIp2Tel_SourceAddress,
NumberMapIp2Tel_NumberType,
NumberMapIp2Tel_NumberPlan,
NumberMapIp2Tel_RemoveFromLeft,
NumberMapIp2Tel_RemoveFromRight,
NumberMapIp2Tel_LeaveFromRight,
NumberMapIp2Tel_Prefix2Add,
NumberMapIp2Tel_Suffix2Add,
NumberMapIp2Tel_IsPresentationRestricted;
[\NumberMapIp2Tel]
For example:
[NumberMapIp2Tel]
[\NumberMapIp2Tel]
Notes:
 This table parameter can include up to 100 indices.
 The parameter
NumberMapIp2Tel_IsPresentationRestricted is not
applicable. Set its value to $$.
 The parameters NumberMapTel2Ip_ SrcIPGroupID,
NumberMapIp2Tel_NumberType, and
NumberMapIp2Tel_NumberPlan are not applicable. Set
these to $$.
 RemoveFromLeft, RemoveFromRight, Prefix2Add,
Suffix2Add, LeaveFromRight are applied if the called
and calling numbers match the DestinationPrefix,
SourcePrefix, and SourceAddress conditions.
 The manipulation rules are executed in the following
order: RemoveFromLeft, RemoveFromRight,
LeaveFromRight, Prefix2Add, and Suffix2Add.
 Parameters can be skipped using two dollar signs ('$$').
 The Source IP address can include the 'x' wildcard to
represent single digits. For example: 10.8.8.xx
represents all addresses between 10.8.8.10 and
10.8.8.99.
 The Source IP address can include the asterisk ('*')
wildcard to represent any number between 0 and 255.
For example, 10.8.8.* represents all the addresses
between 10.8.8.0 and 10.8.8.255.
 To configure manipulation of destination numbers for
IP-to-Tel calls using the Web interface, refer to
''Configuring the Number Manipulation Tables'' on page
195).
 For a description on using ini file table parameters, refer
to ''Format of ini File Table Parameters'' on page 273.