AudioCodes mediapack MP-500

Version 5.8 423 October 2009
SIP User's Manual 6. Configuration Parameters Reference
Parameter Description
Web: Source Phone Number
Manipulation Table for Tel to IP Calls
EMS: SIP Manipulations > Source
Telcom to IP
[SourceNumberMapTel2IP]
This ini file table parameter manipulates the source phone
number for Tel-to-IP calls. The format of this parameter is
as follows:
[SourceNumberMapTel2Ip]
FORMAT SourceNumberMapTel2Ip_Index =
SourceNumberMapTel2Ip_DestinationPrefix,
SourceNumberMapTel2Ip_SourcePrefix,
SourceNumberMapTel2Ip_SourceAddress,
SourceNumberMapTel2Ip_NumberType,
SourceNumberMapTel2Ip_NumberPlan,
SourceNumberMapTel2Ip_RemoveFromLeft,
SourceNumberMapTel2Ip_RemoveFromRight,
SourceNumberMapTel2Ip_LeaveFromRight,
SourceNumberMapTel2Ip_Prefix2Add,
SourceNumberMapTel2Ip_Suffix2Add,
SourceNumberMapTel2Ip_IsPresentationRestricted,
NumberMapTel2Ip_SrcTrunkGroupID,
NumberMapTel2Ip_SrcIPGroupID;
[\SourceNumberMapTel2Ip]
For example:
[SourceNumberMapTel2Ip]
SourceNumberMapTel2Ip 0 =
22,03,$$,0,0,$$,2,$$,667,$$,0,$$,$$;
SourceNumberMapTel2Ip 0 =
10,10,*,255,255,3,0,5,100,$$,255,$$,$$;
[\SourceNumberMapTel2Ip]
Notes:
 This table parameter can include up to indices.
 The parameters
SourceNumberMapTel2Ip_NumberType,
SourceNumberMapTel2Ip_NumberPlan are not
applicable. Set these to $$.
 RemoveFromLeft, RemoveFromRight, Prefix2Add,
Suffix2Add, LeaveFromRight, NumberType,
NumberPlan, and IsPresentationRestricted are applied
if the called and calling numbers match the
DestinationPrefix and SourcePrefix conditions.
 The manipulation rules are executed in the following
order: RemoveFromLeft, RemoveFromRight,
LeaveFromRight, Prefix2Add, and Suffix2Add.
 Parameters can be skipped by using two dollar signs
('$$').
 An asterisk ('*') represents all IP addresses.
 IsPresentationRestricted is set to 'Restricted' only if
'Asserted Identity Mode' is set to 'P-Asserted'.
 To configure manipulation of source numbers for Tel-to-
IP calls using the Web interface, refer to ''Configuring
the Number Manipulation Tables'' on page 195).
 For a description on using ini file table parameters, refer
to ''Format of ini File Table Parameters'' on page 273.