EN
13.15 MAINTENANCE TABLE
Please note that the following maintenance frequencies only
apply to normal operating conditions.
If your daily work is more demanding than normal, the
frequency of maintenance must be increased accordingly.
Before each use
Monthly
If damagedor defective
As required
Complete machine Inspect: leaks, cracks, and wear
x
Checks: switch, starter, throttle
trigger and throttle stop lever
Check operation
x
Fuel tank
Inspect: leaks, cracks, and wear
x
Fuel filter
Inspect and clean
x
Replace filter element
x
Every 6 months
Tools
Inspect: damage and wear
x
Replace
x
Clutch
Inspect: (The tool must not
turn with the dead man lever
released)
x
Replace
x
All accessible screws and nuts
(excluding carburettor screws)
Inspect and retighten
x
Air filter
Clean
x
Replace
x
Every 6 months
Cylinder fins and starter casing
slots
Clean
x
Starter rope
Inspect: damage and wear
x
Replace
x
Spark plug
Check electrode gap
x
Replace
x
Every 6 months
Transmission oil
Check level
x
Replace Every 500 hrs
Battery
Recharge
Each time after
storage
87
To Next Page
Loading...
