Brother MFC-9340CDW - Page 315

3-152
Confidential
(5) Remove the Taptite bind B M4x12 screw to release the ten Hooks. Remove the
High-voltage power supply PCB ASSY from the Main body.
Fig. 3-221
Assembling Note:
- Be careful that the Harness of the Main fan and Harness of the Develop release sensor
PCB ASSY are connected.
- Be careful not to damage the Wire cap.
Taptite bind B M4x12
Hook
Hook
Hook
Hook
Hook
High-voltage power supply PCB ASSY
Main body
<Right side>
Harness of Develop
Harness of Main fan
release sensor PCB ASSY