BT Micro Owner’s Manual
67
Select ‘Missed calls - System’ to examine the system store.
This can be selected from any extension.
You will see the following information:
The number and time of the last three calls received are
displayed.
If the call was answered the display will show an ‘A’ on the right-
hand side of the record. If the call was not answered, the ‘A’ will
not be displayed.
The date information for the displayed calls is shown for a few
seconds instead of the time.
You may scroll through the stored numbers and names by
using the Scroll Up () and Scroll Down Key () situated below
the display.
If you press the display Key beside a particular record the
system automatically selects a free line and dials the displayed
number. If the extension is restricted from dialling, or if there is
no line available, you will hear a busy tone.
If an ‘R’ is displayed on the right-hand side of a record, this
indicates that the number has been redialled.
If an ‘A’ is displayed on the right-hand side of a record, this
indicates that the number has been answered.
To set up your system to display caller numbers received on
Analogue lines (CDS service)
For configuration via the web interface, see page 109.
For configuration via the featurephone interface, see page 167.
To associate a caller number with a name, and route its calls
to an extension
For configuration via the web interface, see page 116.
For configuration via the featurephone interface, see page 167.
CDS Stores storing all calls or unanswered calls
To programme the CDS Store to store all calls or unanswered
calls only.
To set up extensions with an individual CDS Store
For configuration via the web interface, see page 104.
For configuration via the featurephone interface, see page 168.
Button Hopping
When Button hopping is enabled if you press a second line key
while on a call on another line the first call is disconnected. With
button hopping off the first call is placed on hold when the
second line key is pressed.
Paging
To make an announcement over the speakers of all
featurephones
The 'Page All Featurephones’ allows any extension to make an
announcement over the speakers of all featurephones. Only
featurephones that are page-protected will not be paged.
From the Idle Menu, press the Scroll Down Key () until ‘Page
all Featurephones’ is displayed.
Select ‘Page all Featurephones’.
Make your announcement.
From a standard telephone, the code is 795.
To Next Page
Loading...
Need help?
General