Ceia THS/21 - Accessing the Programming Menu

4
FI002K0018v1530hUK – THS/21 Instruction manual for installation, use and maintenance
USE OF THE DEVICE
160 ORIGINAL INSTRUCTION
4.5 Programming access
When the Metal Detector is started for the first time, it is configured for 6 users with permissions
defined in the Programming Manual, including the Administrator user.
To enter the Programming mode press the key. The Metal Detector will ask you to enter a
username and a password.
In case the access level without authentication (user 000000) is enabled, after pressing P the screen will list the enabled
menus for that access level. In order to access a different level, hold the P key pressed until the password request will
prompt.
They are entered using the keypad or using the and keys
and confirming each character with the key.
Password
***#__
After the password has been entered, the Metal Detector is inhibited, access to programming is
given, and the display shows the parameters available for the programming level in question:
Parameter
name
Parameter
value
Cursor
Sensitivity~~~~~~265@
Products
Example of display output during operator-level programming
4.5.1 Password modification
If no password has been assigned, by the Administrator, this function is not available.
THS/xx21E THS/xx21
Access to Programming phase and, with the
cursor positioned on the first voice of any menu,
press the key for at least 5 seconds.
P
ro
d
uc
t
PROD01*
P
ro
d
uc
t
~~~~~~
PROD01
§
The screenshot beside will be prompted.
Press again to confirm.
====================
Do you want to
change password?
^UP^=YES------NO=^E^
[
\
\
\
\
\
\
\
\
\
\
\
\
\
\
\
\
\
\
]
Do you want to
change password?
{| $=YES ||| NO=E |}
Insert the new password and confirm with .
===
N
ew passwor
d
==
______
--------------------
[\\ New password \]
#_____
{||||||||||||||||||}