Overview
III. Chassis, vehicle body accessories
8. Check tire pressure and
wear, correct tire pressure, and
rotate tires if necessary
9. Wheel, steering and
suspension installation
fastening and abnormal noise
10. Fastening of drive shaft
and power battery
11. Check the door hinge, latch,
door stopper, front cabin cover,
cargo container cover hinge
and locking device
12. Check the function and
wear of safety belt
13. Inspection and adjustment
of front wheel alignment and
dynamic balance
Check on specific
requirements
14. Computer detection: read
fault storage information in
each system controller with
special diagnostic equipment
15. Light signal, wire,
connector and fixation
16. Function inspection of
electric equipment (electric
window lifter, central lock, air
conditioner, etc.)
17. Check the air conditioner
(refrigeration and PTC heating),
ventilation system and
condensate drain
18. Headlamp beam, adjust if
necessary
19. Central door lock remote
control battery
Replace every 40000 km or 2
years
20. Trial run: power
performance, braking
performance, smoothness,
noise, gear, etc.
Conduct trial run and inspection after completing all
maintenance work
To Next Page