Power distribution and control system
424
6. Remove the PTC cable fixing clip - as
shown by the arrow - and remove the PTC
cable - 1 -.
1. The installation sequence is the reverse of
the removal sequence.
15.3.7 Removal and installation of compressor harness
Removal and installation
△!
Danger
There is high voltage and high temperature inside the product. Please do not touch
internal components, which may cause electric shock or burns.
△!
Danger
Wait for 15 minutes after disconnecting the negative battery cable.
△!
Danger
When disassembling and repairing accessories with high voltage electricity, it is necessary to
prepare high voltage protective equipment (insulating shoes, insulating gloves, insulating hooks, and
insulating pads).
△!
Caution
Connect the harness connector securely, making sure you hear a click. Fault may occur if there is
no secure connection.
To Next Page
Loading...