CENNTRO LOGISTAR 100 - Electrical Diagnosis

Electrical accessories
449
16.3.3 Electrical diagnosis
Use a dedicated diagnostic instrument to diagnose and detect fault codes, and find the cause of
the fault through fault code prompts.
Fault code list and cause analysis
DTC
Display
DTC
Meaning
Faults
Attribut
e
Trigger Conditions
(Criteria used to
determine an
"active" failure
condition)
Recovery
Conditions
(Criteria used to
determine that a
failure condition is
no longer present )
method of DTC
clearing
DTC
Display
code
DTC
meaning
Fault
attribut
es
Trigger conditions
(criteria used to
determine the
existence of an
"active" failure
condition)
Recovery conditions
(criteria used to
determine the
existence of a
failure condition
that no longer
exists)
DTC clearing
method
U007488
CAN BUS
OFF
Networ
k fault
BUS OFF fault
detected twice
Recover the fault
after receiving 12
consecutive 128
hidden bits
1. Clear using
the diagnostic
(tester)
2. DTC self
recovery after 40
IGN cycles
U010087
Brake
pedal
signal
loss
Networ
k fault
CANID: 0X2550
(EMS_Brake
Pedial Status)
has not received
data
corresponding to
10 consecutive
frames
CANID:0X250
(EMS_Brake Pedal
Status) has
received data
corresponding to
1 consecutive
frame
1. Clear using
the diagnostic
(tester)
2. DTC self
recovery after 40
IGN cycles
U012287
ABS node
loss
Networ
k fault
CANID:0X219
has not received
data
corresponding to
10 consecutive
frames
CANID:0x219
has received data
corresponding to
1 consecutive
frame
1. Clear using
the diagnostic
(tester)
2. DTC self
recovery after 40
IGN cycles