Cessna 182 1978 - Page 100

MODEL
182 & T182 SERIES
SERVICE MANUAL
CESSNA PROGRESSIVE CARE
MODEL 182 & T182
OPERATION
NO.
4
Registration No. Airplane Model and SN Airplane Time
INSPECTION COMPLETED BY
M 7 Oxygen System - Inspect masks, hoses, lines, and fittings
for
condition. routing. and
support. Test operation
and
check for leaks.
N I Vacuum System
- Inspect for condition
and security.
N 2 Vacuum System Hoses - Inspect for hardness.
deterioration. looseness,
or collapsed
hoses.
N 4 Vacuum System Air Filter - Inspect for damage,
deterioration
and contamination.
Clean or replace,
if
required.
NOTE: Smoking will cause premature filter clogging.
N 5 Vacuum
System relief Valve - Inspect
for condition and
security.
N 6 Instruments - Check
general condition and
markings for
legibility.
N 7 Instrument Lines. Fittings. Ducting. and Instrument Panel
Wiring
- Check for proper routing,
support. and security
of
attachment.
N 8 Static System
- Inspect for security
of installation.
cleanliness. and evidence of damage.
N
9 Navigation Indicators.
Controls, and Components -
Inspect
for condition and security.
N
12 Instrument Panel Mounted
Avionics Units (Including
Audio
Panel. VHF Nav/Com(s). ADF, Transponder. DME. and
Compass System)
- Inspect for deterioration,
cracks, and
security of instrument
panel mounts.
Inspect for security of
electrical connections.
condition.
and security of wire
routing.
N 13 Avionics Operating Controls - Inspect for security and
proper
operation of controls and
switches and ensure that
all digital segments will illuminate properly.
N 14 Remote Mounted Avionics - Inspect for security of units
and
electrical connectors,
condition and security
of wire
routing. Also check for evidence of damage and
cleanliness.
N 15 Microphones.
Headsets. and Jacks
- Inspect for
cleanliness. security, and evidence of damage.
O 1 General Airplane
and System Wiring
- Inspect for proper
routing, chafing, broken or loose terminals, general
condition. broken or inadequate clamps, and sharp bends
in
wiring
O 2 Instrument. Cabin.
Navigation. Beacon. Strobe,
and Landing
Lights -
Check operation, condition
of lens. and security
of
attachment.
O 3 Circuit Breakers
and Fuses - Check
operation and
condition Check for required number of spare fuses
O 6 Switch and Circuit Breaker Panel. Terminal Blocks, and
Junction Boxes - Inspect wiring and terminals for condition
and security
O 8 Switches - Check operation. terminals wiring, and
mounting for conditions. security. and interterence
Revision 3 2-67