Cessna 182 1978 - Page 99

MODEL 182 & T182 SERIES SERVICE MANUAL
CESSNA PROGRESSIVE CARE
MODEL 182 & T182
OPERATION
NO. 4
Registration No.
Airplane Model and SN
Airplane Time
INSPECTION COMPLETED BY
J 13 Alternator.
Mounting Bracket, and
Electrical Connections -
Check condition
and security Check
alternator belts for
condition and proper adjustment
Refer to Paragraph
16-42
for belt tension
J 15 Oil Cooler - Check for obstructions, leaks. and security of
attachment
J 16
Exhaust System
- Inspect for
cracks and security
Air leak
check exhaust system. Refer to Section 11 and 11A.
Paragraphs
11-98 and 11-75A,
for inspection procedures.
J 17 Exhaust System
(turbocharged engine)
- Inspect couplings,
seals, clamps, and
expansion joints for
cracks. Air leak
check exhaust system.
J 28
Hoses. Metal
Lines, and
Fittings - Inspect
for signs of
oil
and fuel
leaks. Check for abrasions.
chafing. security,
proper routing
and support and for
evidence of
deterioration
J 31
Turbocharger
(if applicable)
a. Inspect turbocharger mounting bracket, ducting,
linkage, and attaching parts for general condition, leakage
or damage,
and security
of attachment
b. Check
waste gate. actuator,
controller. oil and vent
lines, overboost
relief valve, and
compressor housing for
leakage, apparent
damage, security of attachment,
and
evidence
of wear. Check
waste gate return spring
for
condition and security.
J 33
Engine
Baffles and
Seals
- Check condition
and
security
of
attachment
J 34
Engine Oil
Change
Short
Oil Filter
(approximately
4.8 inches)
a Replace
Filter.
b Add
recommended
grade aviation
oil to replace
oil lost
in
existing
filter
Without Oil Filter - Drain oil sump and oil cooler. inspect
and
clean screens. and refill
with recommended
grade
aviation oil.
K 4
Fuel Tank or Bladder Drains
- Drain water and sediment.
K 6
Fuel Selector Valve - Check
controls for detent in each
position, security of attachment,
and for proper
placarding.
L 1 Propeller Mounting - Check for security of installation.
L 2 Propeller
Blades - Inspect for cracks,
dents, nicks.
scratches. erosion, corrosion. or other damage.
L
3 Spinner -
Check general
condition
and attachment.
L 7 Propeller
Governor and Control -
Inspect for oil and grease
leaks.
L 8 Propeller Anti-ice
Slip Rings, Brushes, and Boots
- Inspect
for condition, and security Perform operational check.
M 3 Cabin Heal and
Ventilation Controls - Check
freedom of
movement through
full travel Check friction
locks for
proper operation.
M 4 Pitot Tube
and Stall Warning Vane - Check
for condition
and obstructions
M 5
Pitot Tube Heater
Element
- Perform operational
check
M 6
Heated Windshield Panel
- Check operation, security
of
installation, electrical wiring, and condition of storage bag.
2-66 Revision 3