Cessna 182 1978 - Page 111

MODEL 182
& T182 SERIES SERVICE
MANUAL
MODEL 182 & T182
OPERATION NO. 4
MECHANIC
INSPECTOR
REMARKS
3. Elevator,
Hinges,
and Cable
Attachment
- Check
condition,
security, and operation.
4. Elevator
Trim Tab
and Hinges
- Check condition,
se-
curity,
and operation.
5. Elevator
Trim Tab Actuator - Free-play
limits inspec-
tion.
6.
Elevator Trim System
- Check cables, push-pull
rods, bellcranks,
pulleys, turnbuckles,
fairleads, rub
strips,
etc. for proper routing,
condition, and secu-
rity.
7. Elevator/Rudder
Downspring
- Check
structure,
bolts,
linkage, bellcrank,
and
push-pull
tube for con-
dition,
operation,a
nd security.
Check cables
for ten-
sion,
routing,
fraying,
corrosion,
and turnbuckle
safety. Check travels
if cables require
tension ad-
8. Rudder - Inspect
the rudder skins for
cracks and
loose rivets, rudder
hinges for condition, cracks
and
security;
hinge bolts,
hinge
bearings,
hinge attach
fittings,
and bonding
jumper
for evidence
of dam-
age
and wear,
failed fasteners,
and
security.
Inspect
the rudder
hinge bolts
for proper
safetying
of nuts
with cotter
pins. Inspect
balance
weight
for loose-
ness
and the
supporting
structure
for damage.
9. Rudder,
Tips, Hinges,
and Cable
Attachment
- Check
condition,
security, and
operation.
10. Elevator
Control System - Inspect
pulleys, cables,
sprockets,
bearings,
chains,
and
turnbuckles
for
condition,
security,
and operation.
11.
Rudder
- Check
internal
surfaces
for corrosion,
con-
dition
of fasteners,
and balance
weight
attachment.
12.
General
Airplane
and
System
Wiring
- Inspect
for
proper
routing, chafing, broken
or loose terminals,
general condition,
broken or inadequate
clamps,
and sharp
bends
in wiring.
Sheet 13 of 14
Revision
1 2-79