Cessna 182 1978 - Page 63

MODEL
182
& T182 SERIES
SERVICE
MANUAL
SPECIAL
EACH EACH EACH INSPECTIONS
2-50.
INSPECTION TIME LIMITS. (MODEL
182 50
100 200
& T182 AIRPLANES.)
HOURS
HOURS HOURS HOURS YEARS
J
1 Cowling and
Cowl Flaps
- Inspect for cracks,
dents, and
other
damage, security
of cowl fasteners, and
cowl
mounted
landing lights
for attachment.
Check
cowl flaps
for condition,
security. and
operation.
,.
2 Engine
- Inspect for evidence
of oil and
fuel leaks. Wash
engine
and check for security
of accessories
3 Engine Controls and Linkage - Check
general condition.
E
freedom
of
movement
through
full range.
Check
for
proper travel.
security
of attachment,
and for
evidence of
wear. Check friction locks for proper operation.
4 Cowl Flap
Controls. Check
freedom of
movement through
full travel.
J
5 Ignition
Switch and
Electrical
Harness
- Inspect
for
damage.
condition, and
security.
J 6
Firewall Structure -
Inspect for wrinkles,
damage, cracks,
sheared rivets,
etc.
Check cowl
shock mounts
for
condition and security.
J
7 Engine
Shock Mounts,
Engine
Mount Structure,
and
Ground Straps
- Check condition, security,
and alignment.
., 8
Induction
System
- Check security
of clamps,
tubes.
and
ducting. Inspect for evidence of leakage.
J 9 Induction
Air Filter - Remove
and clean. Inspect
for
F
damage. and service
per paragraph 2-24.
J
10 Induction
Airbox,
Valves. Doors,
and Controls
- Remove
air filter and inspect hinges, doors, seals, and attaching
parts for wear and
security. Check operation.
Clean and
inspect air filter
and re-oil if flock-coated.
J 11 Alternate
Induction Air
System - Check
for obstructions,
operation. and security.
J 12 Alternator - Check brushes, leads, commutator or slip ring G
for wear.
J
13 Alternator,
Mounting Bracket,
and Electrical
Connections
-
Check
condition and
security.
Check alternator
belts
for
condition and
proper adjustment.
Refer
to Paragraph
16-42
for belt tension.
J
14 Starter, Starter Solenoid, and Electrical
Connections -
H
Check
for condition of starter brushes,
brush leads, and
commutator.
J 15 Oil Cooler
- Check for
obstructions,
leaks, and security
of
attachment.
J
16
Exhaust
System
- Inspect
for
cracks
and
security.
Air
leak
check
exhaust
system.
Refer to Section
11 and
11A,
Paragraphs
11-98
and 11-75A,
for inspection
procedures.
J
17
Exhaust
System
(turbocharged
engine)
- Inspect
couplings.
seals, clamps,
and expansion
joints
for cracks.
Air leak check exhaust system.
J
18 Auxiliary (Electric)
Fuel Pump
(T182) - Check
pump and
fittings for condition, operation, security. Remove and
clean
filter
(as
applicable).
J 19
Engine-Driven
Fuel Pump
- Check for evidence
of leakage,
security of
attachment, and general
condition.
J 20 Magnetos -
Inspection, lubrication. and
overhaul
procedures.
2-32
Revision
3