Cessna 182 1978 - Page 64

MODEL 182 & T182
SERIES SERVICE
MANUAL
SPECIAL
EACH
EACH EACH
INSPECTIONS
2-50 INSPECTION
TIME LIMITS.
(MODEL 182
50 100 200
& T182
AIRPLANES.)
HOURS
HOURS
HOURS HOURS
YEARS
J 21 Magnetos
- Check
external
condition, security,
and
J
electrical leads
for condition. Check
timing to engine and
internal timing if engine timing requires adjustment.
J 22 Magnetos - Timing procedures
and intervals.
K
J 23 Ignition Harness
and Insulators - Check for proper
routing,
deterioration.
and condition
of terminals.
J 24 Spark
Plugs - Remove, clean analyze,
test. gap, and
rotate top plugs-to-bottom and bottom plugs-to-top.
J 25 Cylinder Compression - Perform differential compression
test.
J 26 Carburetor - Drain and flush carburetor bowl. clean inlet
strainer,
and drain plug.
Check
general condition
and
security.
J
27 Engine Primer - Check for leakage,
operation, and
security.
J 28 Hoses.
Metal Lines,
and Fittings
- Inspect for
signs of oil
L
and fuel leaks. Check
for abrasions, chafing,
security,
proper
routing and
support
and for
evidence
of
deterioration.
J 29 Cold
and Hot Air Hoses · Check condition.
routing, and
security.
J 30 Engine Cylinders. Rocker
Box Covers. and Pushrod
·
Housings
- Check for fin damage.
cracks, oil leakage,
security of attachment. and general condition.
J 31 Turbocharger (if applicable) M
a. Inspect
turbocharger mounting
bracket. ducting,
linkage. and
attaching parts
for general con-
dition,
linkage or damage.
and security
of
attachment.
b.
Check waste gate, actuator,
controller, oil and
·
vent
lines. overboost
relief valve, and
com-
pressorhousing for leakage. apparent damage.
security of attachment.and evidence of wear.
Check waste gate return spring for con-
dition
and
security.
J 32 Turbocharger
(if applicable)
a. Remove
heat shields and inspect
for burned
areas,
bulges or cracks
Remove tailpipe and
ducting - inspect
turbine for coking,
carbonization.
oil deposits. and turbine impellers for damage
J 33 Engine Baffles and Seals - Check condition and security of
attachment
J 34 Engine
Oil Change
N
Short Oil
Filter (approximately
4 8 inches)
a Replace Filter.
b Add recommended
grade aviation
oil to replace
oil
lost in existing filter
Without Oil
Filter - Drain oil sump and
oil cooler. Inspect
and clean
screens, and refill with
recommended grade
aviation oil
J 35 Long Oil
Filter (approximately
5 8 inches) Drain
oil sump
N
and oil cooler, replace filler element, refill with
recommended
grade
aviation oil.
Revision
2
2-33