Cessna 182 1978 - Page 91

MODEL 182 &
T182 SERIES SERVICE
MANUAL
CESSNA PROGRESSIVE CARE
MODEL 182 & T182
OPERATION NO. 3
Registration
No. Airplane Model
and SN AirplaneTime
INSPECTION COMPLETED BY
G 1
Elevator Control - Check freedom
of movement and proper
operation through
full travel with
and without flaps
extended.
G 2 Elevator. Hinges,
and Cable Attachment
- Check condition.
security. and operation.
H
1 Elevator
Trim Tab and
Hinges - Check
condition, security.
and operation.
H 4 Elevator
Trim Tab Stop Blocks -
Inspect for damage and
security.
H
6 Elevator
Trim Tab Actuator
- Free-Play
limits inspection.
Refer to Section
9-9 for cleaning, inspection,
and repair
procedures.
Rudder - Inspect
the rudder
skins for
cracks and
loose
rivets,
rudder hinges for condition.
cracks and security;
hinge bolts,
hinge bearings,
hinge
attach
fittings, and
bonding jumper
for evidence of damage
and wear, failed
fasteners, and security.
Inspect the rudder
hinge bolts for
proper safetying of nuts
with cotter pins. Inspect
balance
weight
for looseness and
the supporting structure
for
damage.
3 Rudder. Tips. Hinges,
and Cable Attachment -
Check
condition,
security,
and operation.
I
4 Rudder
- Check internal
surfaces for
corrosion, condition
of
fasteners, and balance
weight attachment.
J 1 Cowling and
Cowl Faps - Inspect for
cracks, dents, and
other damage, security
of cowl fasteners.
and cowl
mounted
landing lights for attachment.
Check cowl flaps
for
condition,
security,
and operation.
J
2 Engine - Inspect for evidence
of oil and fuel leaks.
Wash
engine and
check for security
of accessories.
J
3 Engine.
Propeller Controls.
and Linkage
- Check
general
condition, freedom of movement
through full range.
Check
for
proper travel, security of
attachment, and for evidence
of wear. Check friction locks for proper operation.
J 4
Cowl Flap Controls - Check
freedom of movement through
full
travel.
J
5 Ignition Switch
and Electrical
Harness
- Inspect for damage,
condition, and security.
J 8 Induction
System
- Check security
of clamps,
tubes, and
ducting. Inspect for evidence of leakage
J 9 Induction Air Filter - Remove and clean. Inspect for
damage, and service per paragraph 2-24
J 10 Induction
Airbox. Valves. Doors, and
Controls - Remove air
filter
and inspect
hinges,
doors. seals.
and attaching
pans
for wear
and security. Check operation
Clean and inspect
air filter
and re-oil if flock-coated
J 11 Alternate Induction
Air System - Check for
obstructions,
operation.
and security.
J
13 Alternator. Mounting
Bracket. and Electrical Connections
-
Check
condition
and security
Check
alternator
belts for
condition and
proper adjustment.
Refer
to Paragraph
16-42
for
belt
tension.
J 15 Oil Cooler - Check
for obstructions, leaks. and
security of
attachment.
2-58
Revision
3