Cessna 182 1978 - Page 92

MODEL 182 & T182
SERIES SERVICE
MANUAL
CESSNA
PROGRESSIVE
CARE
MODEL
182 &
T182
OPERATION
NO.
3
Registration No. Airplane
Model and SN
AirplaneTime
INSPECTION COMPLETED BY
J 16 Exhaust
System - Inspect for cracks
and security. Air leak
check exhaust
system. Refer to Section
II and 11A.
Paragraphs 11-98
and 1-75A. for inspection
procedures.
J 17 Exhaust System (turbocharged engine) - Inspect couplings.
seals. clamps,
and expansion
joints for
cracks.
Air leak
check exhaust system.
J 18 Auxiliary
(Electric)
Fuel Pump - Check
pump and
fittings for
condition.
operation.
security.
Remove
and clean
filter (as
applicable).
J
19 Engine-Driven
Fuel
Pump - Check
for evidence of
leakage.
security of attachment,
and general
condition.
J 21 Magnetos
- Check
external
condition. security,
and
electrical
leads
for
condition.
Check
timing
to engine
and
internal timing
if engine timing requires
adjustment.
J 23
Ignition Harness
and Insulators
- Check for
proper routing.
deterioration,
and
condition of terminals.
J
24 Spark
Plugs - Remove,
clean analyze,
test. gap. and
rotate
top plugs-to-bottom
and bottom
plugs-to-top.
J
26 Carburetor
-
Drain and
flush carburetor
bowl.
clean
inlet
strainer. and drain plug.
Check general condition
and
security
J
27 Engine Primer
- Check
for leakage, operation.
and security.
J 28
Hoses.
Metal Lines.
and Fittings
- Inspect
for
signs of
oil
and
fuel leaks.
Check for
abrasions.
chafing. security.
proper
routing
and support
and for
evidence
of
deterioration.
J
29
Cold and
Hot Air Hoses
- Check
condition.
routing,
and
security.
J
30 Engine
Cylinders.
Rocker
Box
Covers,
and Pushrod
Housings
- Check for fin
damage. cracks, oil leakage.
security
of attachment. and
general condition
J 31 Turbocharger
(if applicable)
a. Inspect
turbocharger
mounting
bracket.
ducting.
linkage,
and attaching
parts
for general
condition,
leakage
or damage, and
security of attachment
b. Check
waste
gate,
actuator,
controller,
oil
and vent
lines. overboost
relief
valve, and
compressor
housing for
leakage.
apparent
damage, security
of attachment.
and
evidence of
wear Check
waste
gate return
spring for
condition
and
security.
J
33 Engine Baffles
and Seals
- Check condition
and security
of
attachment
J 34
Engine Oil
Change
Short
Oil Filter
(approximately
4
8 inches)
-
a Replace Filter
b Add
recommended
grade aviation
oil to replace
oil lost
in existing
filter.
Without
Oil Filter
- Drain oil
sump and
oil cooler. Inspect
and clean
screens.
and refill
with recommended
grade
aviation oil
J
35 Long
Oil Filter
(approximately
5 8
inches)
- Drain oil
sump
and
oil cooler. replace
filter element refill
with
recommended
grade
aviation oil
Revision
3
2-59