Cessna 182 1978 - Page 97

MODEL 182 & T182 SERIES SERVICE MANUAL
CESSNA PROGRESSIVE CARE
MODEL
182 &
T182
OPERATION
NO. 4
Registration
No. Airplane
Model and SN Airplane
Time
INSPECTION COMPLETED BY
A
1 Placards
and Decals
- Inspect presence,
legibility,
and
security. Consult Pilot's Operating Handbook and FAA-
Approved Airplane Flight Manual for required placards.
B
1 Fuselage Surface - Inspect
for skin damage, loose
rivets.
condition
of paint. and check pitot-static
ports and drain
holes for obstruction.
Inspect covers
and fairings for
security.
B 2 Internal Fuselage
Structure - Inspect bulkheads,
doorposts.
stringers, doublers, and skins for corrosion, cracks,
buckles, and loose rivets, bolts and nuts.
B 3 Control Wheel
Lock - Check general condition
and
operation.
B
4 Fuselage Mounted Equipment
- Check for general condition
and
security of
attachment.
B 5
Antennas and Cables - Inspect
for security of attachment.
connection, and condition.
B 6 Emergency Locator Transmitter - Inspect for security of
attachment
and check operation
by verifying transmitter
output. Check cumulative time and useful life of batteries
in accordance with FAR
Part 91.207. Refer to
Section 16 -
Emergency
Locator
Transmitter
-
Checkout
Interval.
B 7 Instument Panel Shock Mounts, Ground Straps, and
Covers
- Inspect for deterioration,
cracks, and security
of
attachment.
B
8 Pilot's and Copilot's
Inertia Reels - Inspect for security
of
installation, proper operation. and evidence of damage.
B 9 Seats. Seat Belts, and Shoulder Harnesses - Check general
condition and security.
Check operation of seat
stops and
adjustment
mechanism Inspect belts
for condition and
security of fasteners.
B 10
Windows. Windshield.
Doors,
and Seals
- Inspect general
condition. Check latches,
hinges. and seals for
condition.
operation. and
security of attachment.
B 12
Flight Controls - Check freedom
of movement and proper
operation
through full travel
with and without
flaps
extended.
Check electric trim
controls for operation (as
applicable.)
B
14 Portable
Hand Fire
Extinguisher
- Inspect for
proper
operating
pressure. condition,
security of installation,
and
servicing date.
B
15 Seat Tracks and Stops
- Inspect seat tracks for condition
and security of installation.
Check seat track
stops for
damage
and correct location.
Ensure inspection
of seat
rails for cracks EACH 50 HOURS. Refer to Section 3.
B 16 Control
Column - Inspect pulleys,
cables. sprockets.
bearings,
chains.
bungees.
and turnbuckles
for condition
and security.
B 17
Fuel Line and Selector Valve
Drain(s) - Remove plug and
drain.
C 9 Elevator/Rudder
Downspring
- Check structure,
bolts.
linkage, bellcrank.
and
push-pull
tube for
condition,
operation. and security
Check cables for
tension, routing.
fraying.
corrosion, and turnbuckle
safety Check travels
if
cables
require tension adjustment
or if stops are damaged
2-64
Revision
3