Circutor CVM-B100 - Page 163

5.6.17.2.- Conguration of digital inputs, impulse mode.
After selecting the conguration of an input in impulse mode, you must select the input that you
want to congure in this mode:
Digital input 1.
Digital input 2.
When selecting the input to congure with the key
(Figure 136), you can programme the
following parameters:
 The input name.
 The units.
 The decimals.
 The energy meter factor.
Figure 136: Digital inputs conguration screen (impulse mode).
The parameter selected is indicated in white.
The following options appear in the lower area:
● When programming the input name:
Here you will enter the name for recognising the digital input (maximum of 8 characters).
, ... The possible letters and numbers to program.
Delete character, deletes the selected character.
Delete parameter, deletes the characters of the selected parameter.
Previous, selects the previous parameter.
163
Instruction Manual
CVM-B100 - CVM-B150