pool ipv6
To enable distributed address pool service on IPv6 and to enter the IPv6 pool configuration submode, use the
pool ipv6 command in the Global Configuration mode. To disable this feature, use the no form of this
command.
pool ipv6 pool_name
no pool ipv6 pool_name
Syntax Description
Specifies the IPv6 pool name.
pool_name
Command Default
None
Command Modes
Global Configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the pool ipv6 command to enter IPv6 pool configuration submode.
Task ID
OperationTask ID
read, writeip-services
Examples
This is an example of configuring the pool ipv6 command in the Global Configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# pool ipv6 p6 prefix-length 45
RP/0/RSP0/CPU0:router(config-pool-ipv6)#
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
94
Address Pool Service Commands
pool ipv6
To Next Page
Loading...
Need help?
General
