radius-server load-balance
To configure the RADIUS load-balancing options, use the radius-server load-balance command in the
Global Configuration mode. To disable the Radius server load-balance, use the no form of this command.
radius-server load-balance method least-outstanding [batch-size value| ignore-preferred-server]
no radius-server load-balance method least-outstanding
Syntax Description
Specifies the method by which the next host will be picked.method
Picks the server with the least transactions outstanding.least-outstanding
Specifies the batch size for the selection of the server.batch-size
Specifies the batch size value. The value ranges from 1 to 1500. The
default is 25.
value
Disables the preferred server for this server group.ignore-preferred-server
Command Default
None
Command Modes
Global Configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeaaa
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
44
BNG AAA Commands
radius-server load-balance
To Next Page
Loading...
Need help?
General
