tunnel
To configure the amount of time that the peer will be put in a dead cache, use the tunnel command in vpdn
template configuration mode. To disable this feature, use the no form of this command.
tunnel busy list timeout timeout_value
no tunnel
Syntax Description
Specifies the amount of time in seconds that the peer will remain in dead cache.
This value ranges from 60 to 65535.
timeout_value
Command Default
None
Command Modes
VPDN template configuration
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the vpdn template command to enter vpdn template configuration submode.
Task ID
OperationTask ID
read, writetunnel
Examples
This is an example of configuring the tunnel command in vpdn template configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# vpdn template
RP/0/RSP0/CPU0:router(config-vpdn-template)# tunnel busy list timeout 56
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
422
PPPoE LAC-Specific Commands
tunnel
To Next Page
Loading...
Need help?
General
