ppp max-failure (BNG)
To configure the maximum number of consecutive Configure Negative Acknowledgments (CONFNAKs) to
permit before terminating a negotiation, use the ppp max-failure command in an appropriate configuration
mode. To disable the maximum number of CONFNAKs and return to the default, use the no form of this
command.
ppp max-failure retries
no ppp max-failure
Syntax Description
Maximum number of CONFNAKs to permit before terminating a negotiation. Range
is from 2 to 10. Default is 5.
retries
Command Default
retries: 5
Command Modes
Dynamic template configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
This command was supported in the dynamic template configuration
mode for BNG.
Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
To enter the dynamic template configuration mode, run dynamic-template command in the Global
Configuration mode.
Task ID
OperationsTask ID
read, writeppp
read, writeaaa
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
391
BNG PPP Commands
ppp max-failure (BNG)
To Next Page
Loading...
Need help?
General
