Examples
This examples shows how to allow duplicate client MAC addresses across different VLANs and interfaces,
using the duplicate-mac-allowed command:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# dhcp ipv4
RP/0/RSP0/CPU0:router(config-dhcpv4)# duplicate-mac-allowed exclude-vlan
Related Commands
DescriptionCommand
Enables Dynamic Host Configuration Protocol
(DHCP) for IPv4 and enters DHCP IPv4 configuration
mode.
dhcp ipv4 (BNG), on page 147
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
157
BNG DHCP Commands
duplicate-mac-allowed
To Next Page
Loading...
Need help?
General
