igmp query-interval
To configure the frequency at which the Cisco IOS XR Software sends Internet Group Management Protocol
(IGMP) host-query messages, use the igmp query-interval command in the dynamic-template configuration
mode. To disable this feature, use the no form of this command.
igmp query-interval seconds
no igmp query-interval
Syntax Description
Specifies the frequency used to send IGMP host-query messages and ranges
between 1 to 3600.
seconds
Command Default
The default query-interval value is 60s.
Command Modes
Dynamic template configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the dynamic-template type ppp command to enter dynamic template type ppp configuration mode.
Task ID
OperationTask ID
read, writemulticast
Examples
This is the example of configuring the igmp query-interval command in the dynamic-template configuration
mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# dynamic-template
RP/0/RSP0/CPU0:router(config-dynamic-template)# type ppp foo
RP/0/RSP0/CPU0:router(config-dynamic-template-type)# igmp query-interval 60
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
338
Multicast Commands
igmp query-interval
To Next Page
Loading...
Need help?
General
