aaa radius attribute nas-port-type
To configure the AAA RADIUS attribute nas-port-type for a physical interface or a VLAN sub-interface, use
the aaa radius attribute nas-port-type command in the interface configuration mode. To remove the
configuration of nas-port-type from the interface or VLAN sub-interface, use the no form of this command.
aaa radius attribute nas-port-type {value | string}
no aaa radius attribute nas-port-type
Syntax Description
The nas-port-type value for the interface or VLAN sub-interface.
The range is from 0 to 44.
value
The nas-port-type name for the interface or VLAN sub-interface.
string
Command Default
None
Command Modes
Interface or VLAN sub-interface configuration
Command History
ModificationRelease
This command was introduced.Release 4.3.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The permissible values for nas-port-type within the given range are 0 - 6, 9, 15 and 30 - 44.
Task ID
OperationTask ID
read, writeaaa
Examples
This example shows how to configure the AAA RADIUS attribute, nas-port-type for each physical interface
:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface gigabitEthernet 0/0/0/0
RP/0/RSP0/CPU0:router(config-if)# aaa radius attribute nas-port-type 15
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
25
BNG AAA Commands
aaa radius attribute nas-port-type
To Next Page
Loading...
Need help?
General
