preferred-role
To configure the initial role preference as master or slave, in a BNG geo redundancy feature scenario, use the
preferred-role command in subscriber redundancy configuration mode. To configure the initial role for a
specific subscriber redundancy group (SRG), use this command in subscriber redundancy group configuration
mode. To remove the preferred role configuration, use the no form of this command.
preferred-role {master| slave}
no preferred-role {master| slave}
Syntax Description
Specifies the preferred role as master.master
Specifies the preferred role as slave.slave
Command Default
None
Command Modes
Subscriber redundancy
Subscriber redundancy group
Command History
ModificationRelease
This command was introduced.Release 5.2.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
This is an optional command.
Task ID
OperationTask ID
read, writeconfig-services
Examples
This example shows how to configure preferred role across all SRGs as master, in BNG geo redundancy
feature scenario:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# subscriber redundancy
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
522
Subscriber Commands
preferred-role
To Next Page
Loading...
Need help?
General
