show lpts punt excessive-flow-trap information
To display the Excessive Punt Flow Trap feature information, use the show lpts punt excessive-flow-trap
information command in the EXEC mode.
show lpts punt excessive-flow-trap information
Syntax Description
This command has no keywords or arguments.
Command Default
None
Command Modes
EXEC mode
Command History
ModificationRelease
This command was introduced.Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
readlpts
read, writebasic-services
Examples
This is an example of show lpts punt excessive-flow-trap information command with ARP and PPPoE
protocols configured with non-default values:
RP/0/RSP0/CPU0:router# show lpts punt excessive-flow-trap information
--------------------------------------------------------------
Global Default Values -
Police Rate: 10 pps
Penalty Timeout: 15 mins
--------------------------------------------------------------
Police Penalty
Rate (pps) Timeout (mins)
Protocol Default Config Default Config Punt Reasons
-------- -------------- -------------- ----------------
ARP 10 15 15 2 ARP
Reverse ARP
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
263
Excessive Punt Flow Trap Commands
show lpts punt excessive-flow-trap information
To Next Page
Loading...
Need help?
General
