igmp query-max-response-time
To configure the maximum response time advertised in Internet Group Management Protocol (IGMP) queries,
use the igmp query-max-response-time command in the dynamic-template configuration mode. To disable
this feature, use the no form of this command.
igmp query-max-response-time seconds
no igmp query-max-response-time
Syntax Description
Specifies the maximum response time, in seconds, advertised in IGMP queries,
and ranges between 1 to 12.
seconds
Command Default
The default query-max-response-time is 10 seconds.
Command Modes
Dynamic template configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the dynamic-template type ppp command to enter dynamic template type ppp configuration mode.
Task ID
OperationTask ID
read, writemulticast
Examples
This is the example of configuring the igmp query-max-response-time command in the dynamic-template
configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# dynamic-template
RP/0/RSP0/CPU0:router(config-dynamic-template)# type ppp foo
RP/0/RSP0/CPU0:router(config-dynamic-template-type)# igmp query-max-response-time 12
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
340
Multicast Commands
igmp query-max-response-time
To Next Page
Loading...
Need help?
General
