show ipsubscriber access-interface
To display the access interface information for IP subscriber, use the show ipsubscriber access-interface
command in the EXEC mode.
show ipsubscriber access-interface {type| interface-path-id| brief| location| location}
Syntax Description
Interface type. For more information, use the question
mark (?) online help function.
type
Physical interface or virtual interface.
Use the show interfaces command to see
a list of all interfaces currently configured on
the router.
Note
For more information about the syntax for the router,
use the question mark ( ? ) online help function.
interface-path-id
Displays the brief summary of IP Subscriber access
interface status and configuration.
brief
Specifies the IP subscriber location.location
Specifies the fully qualified location specification.
location
Command Default
None
Command Modes
EXEC mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
For interface-based static sessions in the BNG, the value of Interface Type field in the show ipsubscriber
access-interface command output is displayed as static.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
286
IPoE Commands
show ipsubscriber access-interface
To Next Page
Loading...
Need help?
General
