relay information authenticate (BNG)
To specify relay agent information option to the policy plane for authentication purposes, use the relay
information authenticate command in the DHCP IPv4 proxy profile configuration mode. To disable the
relay option, use the no form of this command.
relay information authenticate {received| inserted}
no relay information authenticate {received| inserted}
Syntax Description
Authenticate using received relay agent information option.received
Authenticate using inserted relay agent information option.inserted
Command Default
None
Command Modes
DHCP IPv4 proxy profile configuration
Command History
ModificationRelease
This command was introduced.Release 4.3.1
Usage Guidelines
No specific guidelines impact the use of this command.
Task ID
OperationsTask ID
read, writeip-services
Examples
This example shows how to specify the received relay agent information option for authentication using the
relay information authenticate command in DHCP IPv4 proxy profile configuration mode:
RP/0/RSP0/CPU0:router# config
RP/0/RSP0/CPU0:router(config)# dhcp ipv4
RP/0/RSP0/CPU0:router(config-dhcpv4)# profile myprofile proxy
RP/0/RSP0/CPU0:router(config-dhcpv4-proxy-profile)# relay information authenticate received
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
183
BNG DHCP Commands
relay information authenticate (BNG)
To Next Page
Loading...
Need help?
General
