This is an example of creating an IPv6 address pool for IPoE subscribers using the dhcpv6 address-pool
command:
RP/0/RSP0/CPU0:router(config)# dynamic-template
RP/0/RSP0/CPU0:router(config-dynamic-template)# type ppp my-ipv6-tempate
RP/0/RSP0/CPU0:router(config-dynamic-template-type)# dhcpv6 address-pool my-ipsub-addr-pool
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
150
BNG DHCP Commands
dhcpv6 address-pool