address-range
To specify address range for allocation, use the address-range command in Pool IPv4 or IPv6 configuration
submode. To remove the address range, use the no form of this command.
address-range first_range last_range
no address-range first_range last_range
Syntax Description
Specifies the first address in range from which the IP addresses can be assigned
to clients.
first_range
Specifies the last address in range until which the IP addresses can be assigned
to clients.
last_range
Command Default
None
Command Modes
Pool IPv4 configuration
Pool IPv6 configuration
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Support for IPv6 was added.Release 4.3.0
Usage Guidelines
You should only specify the addresses that are assignable to clients in a particular subnet. The interface and
broadcast addresses should not be included in the address-range configuration.
Use the pool ipv4 command to enter IPv4 pool configuration submode and pool ipv6 command to enter IPv6
pool configuration submode.
Multiple address-ranges are allowed within a pool.
Task ID
OperationTask ID
read, writeip-services
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
80
Address Pool Service Commands
address-range
To Next Page
Loading...
Need help?
General
