subscriber session limit
To configure a limit for subscriber sessions, use the subscriber session limit command in Global Configuration
mode. To remove the session limit for subscribers, use the no form of this command.
subscriber session limit session_limit
no subscriber session limit [session_limit]
Syntax Description
Limit for subscriber sessions.
The range is from 1 to 200000.
session_limit
Command Default
None
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Release 5.1.1
The session_limit was made an optional parameter for the no form
of this command.
Release 5.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
This command does not limit the number of un-authenticated sessions on the router, until the overall session
count reaches session_limit. If a new session comes up after router reached the session_limit, then the long-lived
un-authenticated subscriber session is deleted. The new session can be an authenticated or un-authenticated
session.
Task ID
OperationTask ID
read, writeconfig-services
Examples
This example shows how to configure a limit for subscriber sessions:
RP/0/RSP0/CPU0:router# configure
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
532
Subscriber Commands
subscriber session limit
To Next Page
Loading...
Need help?
General
