ipv6 nd ra-initial
To set the IPv6 initial router advertisement count and interval, use the ipv6 nd ra-initial command in the
dynamic template configuration mode. To restore the default interval, use the no form of this command.
ipv6 nd ra-initial count interval
no ipv6 nd ra-initial
Syntax Description
The initial count or the initial number of the IPv6 router advertisements. The value
ranges from 0-32.
value
The interval (in seconds) between IPv6 router advertisement counts. The value
ranges from 4-1800.
interval
Command Default
None
Command Modes
Dynamic template configuration
Command History
ModificationRelease
This command was supported in the dynamic template configuration
mode for BNG.
Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
To enter the dynamic template configuration mode, run dynamic-template command in the Global
Configuration mode.
Task ID
OperationsTask ID
read, writeconfig-services
Examples
This example configures an IPv6 router advertisement count of 5 and an interval of 201 seconds in the dynamic
template configuration mode:
RP/0/RSP0/CPU0:router(config)# dynamic-template type ppp p1
RP/0/RSP0/CPU0:router(config-dynamic-template-type)# ipv6 nd ra-initial 5 201
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
365
Neighbor Discovery Commands
ipv6 nd ra-initial
To Next Page
Loading...
Need help?
General
