OperationsTask ID
read, writeconfig-services
Examples
This example (not applicable for BNG) configures the “other stateful configuration” flag in IPv6 router
advertisements on GigabitEthernet interface 0/1/1/0:
RP/0/RSP0/CPU0:router(config)# interface gigabitethernet 0/1/1/0
RP/0/RSP0/CPU0:router(config-if)# ipv6 nd other-config-flag
For BNG, this example configures the “other stateful configuration” flag for IPv6 router advertisements in the
dynamic template configuration mode:
RP/0/RSP0/CPU0:router(config)# dynamic-template type ppp p1
RP/0/RSP0/CPU0:router(config-dynamic-template-type)# ipv6 nd other-config-flag
Related Commands
DescriptionCommand
Sets the managed address configuration flag in IPv6
router advertisements.
ipv6 nd managed-config-flag (BNG), on page 358
Displays the usability status of interfaces configured
for IPv6.
show ipv6 interface (BNG), on page 317
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
364
Neighbor Discovery Commands
ipv6 nd other-config-flag (BNG)
To Next Page
Loading...
Need help?
General
