radius-server ipv4 dscp
To mark the dscp bit for the ipv4 packets, use the radius-server ipv4 dscp command in the Global
Configuration mode. To disable the Radius server IPv4 dscp, use the no form of this command.
radius-server ipv4 dscp value
no radius-server ipv4 dscp value
Syntax Description
Specifies the differentiated services codepoint value. The value ranges from 1 to
63.
value
Command Default
None
Command Modes
Global Configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeaaa
Examples
This is an example of configuring the radius-server ipv4 dscp command in the Global Configuration mode:
RP/0/RSP0/CPU0:router(config)#radius-server ipv4 dscp 34
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
41
BNG AAA Commands
radius-server ipv4 dscp
To Next Page
Loading...
Need help?
General
