ipv6 nd managed-config-flag (BNG)
To set the managed address configuration flag in IPv6 router advertisements, use the ipv6 nd
managed-config-flag command in an appropriate configuration mode. To clear the flag from IPv6 router
advertisements, use the no form of this command.
ipv6 nd managed-config-flag
no ipv6 nd managed-config-flag
Syntax Description
This command has no keywords or arguments.
Command Default
The managed address configuration flag is not set in IPv6 router advertisements.
Command Modes
Interface configuration (not applicable for BNG)
Dynamic template configuration (for BNG)
Command History
ModificationRelease
This command was introduced.Release 3.7.2
This command was supported in the dynamic template configuration
mode for BNG.
Release 4.3.0
Usage Guidelines
Setting the managed address configuration flag in IPv6 router advertisements indicates to attached hosts
whether they should use stateful autoconfiguration to obtain addresses. If the flag is set, the attached hosts
should use stateful autoconfiguration to obtain addresses. If the flag is not set, the attached hosts should not
use stateful autoconfiguration to obtain addresses.
Hosts may use stateful and stateless address autoconfiguration simultaneously.
For BNG, ensure you run this command in the dynamic template configuration mode. To enter the dynamic
template configuration mode, run dynamic-template command in the Global Configuration mode.
Task ID
OperationsTask ID
read, writeipv6
read, writenetwork
read, writeconfig-services
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
358
Neighbor Discovery Commands
ipv6 nd managed-config-flag (BNG)
To Next Page
Loading...
Need help?
General
