pado delay
To set a delay for a PPPoE Active Discovery Offer (PADO) message for a particular PPPoE BBA-Group,
use the pado delay command in PPPoE BBA-Group configuration mode. To disable the PADO delay
configuration, use the no form of this command.
pado delay delay
no pado delay
Syntax Description
Delay value for PADO message, in milliseconds.
The range is from 0 to 10000.
delay
Command Default
None
Command Modes
PPPoE BBA-Group configuration
Command History
ModificationRelease
This command was introduced.Release 4.3.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Setting a value of 0 for delay means that no transmission delay is set for PADO message. Setting a value of
10000 means that an infinite delay is set for PADO message or in other words, PADO message is never sent.
Task ID
OperationTask ID
read, writeppp
Examples
This example shows how to configure a delay of 1000 milliseconds for the PADO message:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# pppoe bba-group bba1
RP/0/RSP0/CPU0:router(config-bbagroup)# pado delay 1000
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
442
PPPoE Commands
pado delay
To Next Page
Loading...
Need help?
General
