initiator unclassified-ip
To enable packet-triggered routed subscriber sessions (IPv4 and IPv6) on an access-interface in BNG, use
the initiator unclassified-ip command in the appropriate configuration sub mode. To disable this feature, use
the no form of this command.
initiator unclassified-ip [prefix-len prefix-len]
no initiator unclassified-ip [prefix-len prefix-len]
Syntax Description
Configures the prefix-length for IPv6 subscriber route.
This option is available only for packet-triggered IPv6 sessions.
prefix-len
Specifies the value of subscriber route prefix-length.
The range is from 0 to 127.
prefix-len
Command Default
None
Command Modes
IP subscriber IPv4 routed configuration
IP subscriber IPv6 routed configuration
Command History
ModificationRelease
This command was introduced.Release 5.2.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writenetwork
Examples
This example shows how to host packet-triggered routed IPv4 subscriber sessions in an access-interface:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface Bundle-Ether101.201
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
274
IPoE Commands
initiator unclassified-ip
To Next Page
Loading...
Need help?
General
