Specifies the VRF in which the IP subscriber interface
operates.
vrf
Command Default
None
Command Modes
EXEC mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
The outer-vlan-id keyword along with an optional inner-vlan-id
keyword was added.
Release 4.3.1
The dynamic-routes keyword was added.Release 5.1
A new output field, Template ID, was added for show ipsubscriber
interface internal command.
Release 5.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
For interface-based static sessions in the BNG, the value of Type field in the show ipsubscriber interface
command output is displayed as Static.
Task ID
OperationTask ID
readnetwork
Examples
This is the sample output of the show ipsubscriber interface command:
RP/0/RSP0/CPU0:router# show ipsubscriber interface
Interface: GigabitEthernet0/1/0/0.11.ip1
Type: L2-connected
Ifhandle: 0x201000c0
Access Interface: GigabitEthernet0/1/0/0.11 (0x20100080)
Subscriber MAC: 0100.0000.0000
Subscriber IP: 11.10.10.9 <------- this line will not be shown if empty
Subscriber IPv6 Prefix: FE80::10 <------- this line will not be shown if empty
Subscriber Label: 0x8000000
IPv4: Initiator: Packet-Trigger <-- this line will not be shown if not enabled
IPv6: Initiator: DHCPv6 <-- this line will not be shown if not enabled
Created: May 11 16:33:08 (age 00:03:08)
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
290
IPoE Commands
show ipsubscriber interface
To Next Page
Loading...
Need help?
General
