ipv6 nd other-config-flag (BNG)
To set the other stateful configuration flag in IPv6 router advertisements, use the ipv6 nd other-config-flag
command in an appropriate configuration mode. To clear the flag from IPv6 router advertisements, use the
no form of this command.
ipv6 nd other-config-flag
no ipv6 nd other-config-flag
Syntax Description
This command has no keywords or arguments.
Command Default
The other stateful configuration flag is not set in IPv6 router advertisements.
Command Modes
Interface configuration (not applicable for BNG)
Dynamic template configuration (for BNG)
Command History
ModificationRelease
This command was introduced.Release 3.7.2
This command was supported in the dynamic template configuration
mode for BNG.
Release 4.3.0
Usage Guidelines
The setting of the other stateful configuration flag in IPv6 router advertisements indicates to attached hosts
how they can obtain autoconfiguration information other than addresses. If the flag is set, the attached hosts
should use stateful autoconfiguration to obtain the other (nonaddress) information.
If the managed address configuration flag is set using the ipv6 nd managed-config-flag command, then
an attached host can use stateful autoconfiguration to obtain the other (nonaddress) information regardless
of the setting of the other stateful configuration flag.
Note
For BNG, ensure you run this command in the dynamic template configuration mode. To enter the dynamic
template configuration mode, run dynamic-template command in the Global Configuration mode.
Task ID
OperationsTask ID
read, writeipv6
read, writenetwork
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
363
Neighbor Discovery Commands
ipv6 nd other-config-flag (BNG)
To Next Page
Loading...
Need help?
General
