show lpts punt excessive-flow-trap
To display the bad actor flows trapped by Excessive Punt Flow Trap (EPFT), use the show lpts punt
excessive-flow-trap command in the EXEC mode.
show lpts punt excessive-flow-trap {protocol | interface interface-type interface-path-id | information}
[location]
Syntax Description
Enter the protocol type.
• arp—Displays ARP bad actors.
• icmp—Displays ICMP bad actors.
• dhcp—Displays DHCP bad actors.
• pppoe—Displays PPPoE bad actors.
• ppp—Displays PPP bad actors.
• igmp—Displays IGMP bad actors.
• ipv4—Displays IPv4 bad actors.
• l2tp—Displays L2TP bad actors.
• all—Displays bad actors for all protocols.
protocol
Displays the bad actors on an interface. For more information on the interface types, use
the question mark (?) online help function.
interface
Specifies the interface type. For more information, use the question mark (?) online help
function.
type
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
260
Excessive Punt Flow Trap Commands
show lpts punt excessive-flow-trap
To Next Page
Loading...
Need help?
General
