show ipv6 traffic (BNG)
To display the IPv6 traffic statistics, use the show traffic command in the EXEC mode.
show ipv6 traffic [brief]
Syntax Description
(Optional) Displays only IPv6 and Internet Control Message Protocol version 6
(ICMPv6) traffic statistics.
brief
Command Default
None
Command Modes
Command History
ModificationRelease
This command was introduced.Release 3.7.2
This command was supported for BNG.Release 4.3.0
Usage Guidelines
The show ipv6 traffic command provides output similar to the show ipv4 traffic command, except that it is
IPv6-specific.
Task ID
OperationsTask ID
readipv6
readnetwork
Examples
This is the sample output of the show ipv6 traffic command:
RP/0/RSP0/CPU0:router# show ipv6 traffic
IPv6 statistics:
Rcvd: 0 total, 0 local destination
0 source-routed, 0 truncated
0 format errors, 0 hop count exceeded
0 bad header, 0 unknown option, 0 bad source
0 unknown protocol
0 fragments, 0 total reassembled
0 reassembly timeouts, 0 reassembly failures
0 reassembly max drop
0 sanity address check drops
Sent: 0 generated, 0 forwarded
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
330
IPv4 and IPv6 Commands
show ipv6 traffic (BNG)
To Next Page
Loading...
Need help?
General
