Cisco A9K-SIP-700 Command Reference

0 fragmented into 0 fragments, 0 failed
0 no route, 0 too big
Mcast: 0 received, 0 sent
ICMP statistics:
Rcvd: 0 input, 0 checksum errors, 0 too short
0 unknown error type
unreach: 0 routing, 0 admin, 0 neighbor,
0 address, 0 port, 0 unknown
parameter: 0 error, 0 header, 0 option,
0 unknown
0 hopcount expired, 0 reassembly timeout,
0 unknown timeout, 0 too big,
0 echo request, 0 echo reply
Sent: 0 output, 0 rate-limited
unreach: 0 routing, 0 admin, 0 neighbor,
0 address, 0 port, 0 unknown
parameter: 0 error, 0 header, 0 option
0 unknown
0 hopcount expired, 0 reassembly timeout,
0 unknown timeout, 0 too big,
0 echo request, 0 echo reply
Neighbor Discovery ICMP statistics:
Rcvd: 0 router solicit, 0 router advert, 0 redirect
0 neighbor solicit, 0 neighbor advert
Sent: 0 router solicit, 0 router advert, 0 redirect
0 neighbor solicit, 0 neighbor advert
UDP statistics:
0 packets input, 0 checksum errors
0 length errors, 0 no port, 0 dropped
0 packets output
TCP statistics:s
0 packets input, 0 checksum errors, 0 dropped
0 packets output, 0 retransmitted
This table describes the significant fields shown in the display.
Table 22: show ipv6 traffic Command Field Descriptions
DescriptionField
Statistics in this section refer to packets received by
the router.
Rcvd:
Total number of packets received by the software.total
Locally destined packets received by the software.local destination
Packets seen by the software with RH.source-routed
Truncated packets seen by the software.truncated
An error was found in generic HBH, RH, DH, or HA.
Software only.
bad header
Unknown option type in IPv6 header.unknown option
Protocol specified in the IP header of the received
packet is unreachable.
unknown protocol
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
331
IPv4 and IPv6 Commands
show ipv6 traffic (BNG)

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English