ppp timeout
To configure timeouts for PPP protocol, use the ppp timeout command in the dynamic template configuration
mode. To disable this feature, use the no form of this command.
ppp timeout [ absolute absolute_minutes | authentication auth_seconds | retry retry_seconds ]
no ppp timeout
Syntax Description
Specifies the absolute timeout for a PPP session.absolute
Specifies the maximum wait time to receive an authentication response.authentication
Specifies the maximum time to wait for a response during PPP negotiation.retry
Specifies the absolute timeout in minutes. This value ranges from
0-70000000.
absolute_minutes
Specifies the authentication wait time in seconds. This value ranges from
3-30.
auth_seconds
Specifies the retry timeout in seconds. This value ranges from 1-10.
retry_seconds
Command Default
None
Command Modes
Dynamic template configuration
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the dynamic-template command to enter the dynamic template configuration mode.
Task ID
OperationTask ID
read, writeppp
read, writeaaa
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
395
BNG PPP Commands
ppp timeout
To Next Page
Loading...
Need help?
General
