disable (subscriber redundancy)
To disable BNG geo redundancy feature across all subscriber redundancy groups (SRGs), use the disable
command in subscriber redundancy configuration mode. To disable a specific SRG, use the disable command
in subscriber redundancy group configuration mode. To remove the SRG disable configuration, use the no
form of this command.
disable
no disable
This command has no keywords or arguments.
Command Default
None
Command Modes
subscriber redundancy
subscriber redundancy group
Command History
ModificationRelease
This command was introduced.Release 5.2.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
When geo redundancy feature is disabled, the peering for the SRG(s) is brought down and the role changes
from master (or slave) to NONE. The states that are already mirrored, get cleared from the database. In SRG
disabled state, BNG handles and sets up incoming sessions the same way as it was done without having the
redundancy feature. When feature is re-enabled, the peering sets up again and role negotiation happens. In
this case, the SRG which gets the slave role, loses all its existing sessions and sets up mirror sessions for the
ones it gets from the master.
Task ID
OperationTask ID
read, writeconfig-services
Examples
This example shows how to disable geo redundancy feature for all SRGs:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# subscriber redundancy
RP/0/RSP0/CPU0:router(config-subscr-red)# disable
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
516
Subscriber Commands
disable (subscriber redundancy)
To Next Page
Loading...
Need help?
General
