DescriptionField
Indicates the current state of LCP. The state of the
LCP will report the following states:
• Initial—Lower layer is unavailable (Down), and
no Open has occurred. The Restart timer is not
running in the Initial state.
• Starting—An administrative Open has been
initiated, but the lower layer is still unavailable
(Down). The Restart timer is not running in the
Starting state. When the lower layer becomes
available (Up), a Configure-Request is sent.
• Closed— LCP is not currently trying to
negotiate.
• Stopped—A Terminate-Request has been sent
and the Restart timer is running, but a
Terminate-Ack has not yet been received.
• Closing—A Terminate-Request has been sent
and the Restart timer is running, but a
Terminate-Ack has not yet been received. Upon
reception of a Terminate-Ack, the Closed state
is entered. Upon the expiration of the Restart
timer, a new Terminate-Request is transmitted,
and the Restart timer is restarted. After the
Restart timer has expired Max-Terminate times,
the Closed state is entered.
• Stopping—A Terminate-Request has been sent
and the Restart timer is running, but a
Terminate-Ack has not yet been received.
Req-Sent.
• ACKsent—LCP has received a request and has
replied to it.
• ACKrcvd—LCP has received a reply to a
request it sent.
• Open—LCP is functioning properly
LCP
IPv4 address for the local interface.Local IPv4 address
Maximum receive unit. The maximum size of the
information transported, in bytes, in the PPP packet
received by the local equipment.
Local MRU
Connection open.Open
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
402
BNG PPP Commands
show ppp interfaces (BNG)
To Next Page
Loading...
Need help?
General
