vpn
To configure the VPN ID or VRF name, use the vpn command in vpdn template configuration mode. To
disable this feature, use the no form of this command.
vpn { id vpn_index|vrf vrf_name }
no vpn
Syntax Description
Specifies the VPN ID.id
Specifies the VRF.vrf
Specifies a value between 0-ffffff.
vpn_index
Specifies the name of the vrf.
vrf_name
Command Default
None
Command Modes
VPDN template configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the vpdn template command to enter vpdn template configuration submode.
Task ID
OperationTask ID
read, writetunnel
Examples
This is an example of configuring the vpn command in vpdn template configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# vpdn template
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
426
PPPoE LAC-Specific Commands
vpn
To Next Page
Loading...
Need help?
General
